Already broke my pip boy, haha pushed the button on the top too hard, now its stuck in there. Fml

Silly Homer. The fingers you have used to operate this Pip-Boy are too fat, please try again.

Well look on the bright side, at least you got to break yours before any of us!!

Just one question: when you realised the button was stuck, did you say "doh!"?

No i said, the f word, exact words were " fudge fudge fudgy da fugde fudge ive had this thing for less then 5 minutes and ive already fudged it, FUUUUDGE!!!!"

My face exactly https://www.google.com.au/search?site=webhp&tbm=isch&source=hp&ei=tOFAVo_LJ6LgmAWoi6TgCA&q=rage+face&oq=rage+face&gs_l=mobile-gws-hp.3..0l4j5.2141.4916.0.5730.10.10.0.1.1.0.341.2821.2-9j1.10.0....0...1.1.64.mobile-gws-hp..1.9.2478.0.VDLQuplmAX4#imgrc=yMpw0_Usu6j3nM%3A

So opinion, do you think it broke because it's poorly made or because you are a klutz?

Just wondering.

You could always try to jimmy it out with something like a bobby pin.

There is almost nothing you can't fix with a booby pin and some duct tape.

Its not bad quality, the top button is in there pretty good and feels solid. But me being excited and impatient i tried to open the pip boy to put my phone in without reading the manual. I pushed so hard on the button to open it but nothing happened, so me being me pushed harder. Now it stuck in there.

I'll have to screw it open to pop it back out.

Thanks for the LOL Nibbles...seriously ty.

Depends if it's considered to be advanced, expert, or master.

Yes, I went there

Maybe if you gently try to pries it out. With a bobby pin as Summer suggested.. "Gently Homer.. Gently" Maybe peel off the plastic end of the bobby pin and open it up.

Made in China.

Still made well